Birdboss Fixing & Installation Guide


Setting up your Birdboss is quick and straightforward when you have the right tools and follow the correct steps. This guide walks you through installation on wooden and fibreglass surfaces, as well as how to adjust the pivot post for optimal performance.

Tools & Materials Required

  • Drill
  • Countersink bit (for fibreglass installations)
  • Masking tape (for fibreglass installations)
  • Wax, varnish, or soap (for wooden installations)
  • Sealant (optional)

Included Materials

  • 2 x Stainless Steel Screws (316 Grade)

Installation Videos

Watch our step-by-step guides on how to correctly install and use your Birdboss system — including all mounting methods and maintenance tips.

Fixing Pivot Base

Fixing Flush Mount

Fixing Rail Clamp

Alternate Fixing

Filling Sandbag Mount

Putting on Sails

Follow these step-by-step instructions for secure installation of your Birdboss system on both wooden and fibreglass surfaces.

For Wooden Surfaces

  • Preparation: Identify the exact location where the Birdboss will be mounted.
  • Drill a Pilot Hole: Using a drill, make a pilot hole slightly smaller than the supplied screws.
  • Lubricate the Screw: Apply a small amount of wax, varnish, or soap to the screw threads to ensure smooth installation and prevent wood splitting.
  • Secure the Birdboss: Align the base with the pilot hole and screw it in securely. Ensure it’s level before tightening.
  • Final Check: Avoid overtightening to prevent damage to the wood. Confirm the base is firmly attached.

For Fibreglass Surfaces

  • Preparation: Apply masking tape over the installation area to prevent gel coat flaking.
  • Mark and Drill a Pilot Hole: Drill a 3.5–4.0mm pilot hole at your marked point on the tape.
  • Countersink the Hole: Slightly flare the hole using a countersink bit to avoid surface cracks.
  • Apply Sealant (Optional): Use sealant on the screw for extra waterproofing and hold.
  • Install the Birdboss: Position the base or flush mount and tighten the screws carefully — do not overtighten.

Adjusting the Pivot Post

  • Post Installation: Ensure the pivot and arms are clear of all obstructions.
  • Securing the Pivot Post: Once positioned correctly, tighten the post using an Allen key.

Final Check

  • Confirm the Birdboss is stable and securely attached.
  • Wipe away any excess sealant or lubricant.

Important Notes

  • Do not overtighten screws on any surface — this may cause damage.
  • Regularly check that the pivot post remains secure and well-adjusted.
  • Remove Birdboss when under way or during extreme winds (over 40 knots).

Need help? Contact our support team for installation guidance or product assistance.

Congratulations on installing your Birdboss — enjoy effective and hassle-free bird protection!